Linksys wrt110 validating identity
If the box was checked, then that was why you were getting the “unable to find a certificate to log you on to the network” message because Windows is looking for one, but your wireless router is not setup for certificate security. Once I unchecked that box and tried to reconnect to the wireless network, everything worked fine!
.header_background_full .header_background_slim .welcome-container .wlc-header .wlc-content .linksys-search-form .
I can only got rid of it by going to authentication tab and un-checked the Enable IEEE 802.1x thingy.Note: IEEE 802.1X security is the highest of those available. Because the key is not shared - it's issued by the server, and is unique to your machine. While both WPA2 and WPA security are excellent, their weakness is that the key is shared between all systems on the network.So if you have access (could be physical access, including say a stolen laptop) you will be able to find the key which will allow any system access to the network... However Im still confused of why all of the sudden validating identity shows up right after I replaced the router from DI-624 to DIR-655. All I did was released the IP before I shut down DI-624 and plug the DIR-655 in powered DIR-655 up and off I go.The computers have to match the new setting with the router. HOw do I reset the settings of the computers to match the new router? IEEE 802.1X is the standard which defines authentication against a RADIUS server.Reset or change the security settings on the two wired computers. For right now I just disabled (unchecked) "Enable IEEE 802.1x Authentication for this network" on both wired computers. But now by doing so, would it do any harm to my network? If you have a home network, it's unlikely that you have a RADIUS server - so that's OK.